中心锥有无内突扩的波瓣引射器内流场数值模拟研究

罗虎; 金捷; 杜刚

doi:10.3879/j.issn.1000-0887.2014.05.009

中心锥有无内突扩的波瓣引射器内流场数值模拟研究

doi: 10.3879/j.issn.1000-0887.2014.05.009

北京航空航天大学能源与动力工程学院, 北京 100191

详细信息

作者简介:
罗虎（1988—），男，湖南人，硕士生(E-mail: tgvictor99@yahoo.com)

中图分类号: V231.3;O354.9
计量
- 文章访问数: 1174
- HTML全文浏览量: 63
- PDF下载量: 789
- 被引次数: 0
出版历程
- 收稿日期: 2013-11-22
- 修回日期: 2014-04-03
- 刊出日期: 2014-05-15

Numerical Simulation of Flow Fields in Circularly Lobed Ejectors With/Without Central Plug Sudden Expansion

School of Energy and Power Engineering, Beihang University, Beijing 100191, P.R.China

摘要

摘要: 对中心锥有无内突扩的波瓣引射器内流场进行了CFD仿真模拟和比较分析.对比了两者下游流场流向涡的大小和分布,并以热混合效率和总压恢复系数为性能参数，分析了截锥内突扩对此类引射器性能的影响.结果表明：中心锥内突扩结构能有效降低流动损失，可大幅度提高总压恢复系数.中心锥内突扩结构的扩压作用导致主流的速度降低，使引射器下游的流向涡量降低，但其能给下游流场带来额外的流动扰动，使整个流场的混合效率增加.
- 突扩 /
- 引射器 /
- 流向涡量 /
- 热混合效率 /
- 总压恢复系数
Abstract: The models of lobed ejectors with/without central plug sudden expansion were built. The flow fields by CFD simulation were compared and analyzed with focuses on the sizes and distributions of the downstream streamwise vorticities. Thermal mixing efficiency and total pressure recovery coefficient were used to judge the performances of the two kinds of ejectors. The results show that the central plug with sudden expansion can effectively reduce flow loss and significantly improve the total pressure recovery coefficient. As the central plug sudden expansion causes the mainstream velocity to slow down, the vorticity of the ejector declines in the downstream flow field; but on the other hand, the central plug sudden expansion brings additional flow disturbances to the flow field and makes the mixing efficiency of the whole field increase.
- central plug sudden expansion /
- ejector /
- streamwise vorticity /
- thermal mixing efficiency /
- total pressure recovery coefficient

HTML全文

参考文献(11)

[1]	Pérez W M, Reynolds G, McCormick D. Thrust augment using mixer-ejector-diffuser systems[R]. AIAA paper 94-0020, 1994.
[2]	Pérez W M. Mixer/ejector noise suppressors[R]. AIAA paper 91-2243, 1991.
[3]	季鹤鸣, 樊于军, 杨茂林. 新型内突扩加力燃烧室方案可行性分析[J]. 航空发动机, 2006,32(1): 35-37.(JI He-ming, Fan Yu-jun, YANG Mao-lin. Feasibility analysis of a new inner dumped afterburner concept[J]. Aeroengine,2006,32(1): 35-37.(in Chinese))
[4]	Hu H, Saga T, Kobayashi T, Taniguchi N. Simultaneous measurements of all three components of velocity and vorticity vectors in a lobed jet flow by means of dual-plane stereoscopic particle image velocimetry[J]. Physics of Fluids,2002,14(7): 2128-2138.
[5]	刘友宏, 陈锵, 李立国. 圆排波瓣圆柱混合管的气动特性实验研究[J]. 南京航空航天大学学报, 2000,32(4): 375-380.(LIU You-hong, CHEN Qiang, LI Li-guo. Experimental investigation of internal aerodynamics of periodically axis-symmetry lobed exhaust-ejector mixers[J]. Journal of Nanjing University of Aeronautics & Astronautics,2000,32(4): 375-380.(in Chinese))
[6]	刘友宏, 李立国. 有无中心锥圆排波瓣喷管引射器内流场模拟与比较[J]. 航空动力学报, 2002,17(3): 280-286.(LIU You-hong, LI Li-guo. Numerical simulation of flow field in circularly lobed exhaust-ejector mixer with/without a central plug[J]. Journal of Aerospace Power,2002,17(3): 280-286.(in Chinese))
[7]	刘友宏, 谢翌. 菊花形混合器混合效率理论计算[J]. 航空动力学报, 2009,24(4): 740-745.(LIU You-hong, XIE Yi. Analytical solution of mixing efficiency of lobed mixer[J]. Journal of Aerospace Power,2009,24(4): 740-745.(in Chinese))
[8]	谢翌, 刘友宏. 瓣高宽比对波瓣强迫混合排气系统性能影响[J]. 航空动力学报, 2010,25(12): 2787-2794.(XIE Yi, LIU You-hong. Effect of ratio of height to width of lobe on the performance of a lobed mixer in a forced mixing exhaust system[J]. Journal of Aerospace Power,2010,25(12): 2787-2794.(in Chinese))
[9]	刘友宏, 杜力伟, 谢翌, 邵万仁, 吴飞. 波瓣凹扇修形对波瓣强迫混合排气系统性能影响[J]. 科学技术与工程, 2013,13(18): 5226-5233.(LIU You-hong, DU Li-wei, XIE Yi, SHAO Wan-ren, WU Fei. Effect of elliptical cut at trailing edge of a lobed mixer on aerodynamic and thermal performance of a turbofan forced mixing exhaust system[J]. Science Technology and Engineering,2013,13(18): 5226-5233.(in Chinese))
[10]	谢翌, 李腾, 刘友宏. 波瓣混合器混合流场中涡结构的数值研究[J]. 科学技术与工程, 2011,11(32): 7972-7978.(XIE Yi, LI Teng, LIU You-hong. Numerical investigation of vortical structures in a jet mixing flow of lobed mixer[J]. Science Technology and Engineering,2011,11(32): 7972-7978.(in Chinese))
[11]	Cooper N J, Merati P, Hu H. Numerical simulation of the vortical structures in a lobed jet mixing flow[R]. AIAA-2005-0635, 2005.